Operation And Maintenance (Flat Screen Printing Machine)


We should pay attention to the preparation for starting up, operation and closing down. If you follow that, the service life of the Flat Screen Printing Machine will be extended and work efficiency will be improved. Some operations are as follow.

(1) Prepare the printing process according to the process and sample requirements.

(2) Determine the number of cloth and connect the belt according to the product situation.

(3) Adjust the amplitude of the glue and the thickness of the glue.

(4) Adjust the water washing device.

(5) Carry out registration.

(6) According to the process requirements, grind the blade edge and match the color paste bucket as needed.

(7) Connect the white cloth and the end of the cloth guide band, push the glue-on mechanism, and drive according to the electrical program so that hot air will be circulatory, and drying room will be heated.

(8) After one cycle, the front of the flower cloth is connected with the guide cloth belt in the drying room, the drying room linkage clutch is operated, and the flower cloth enters the drying room.

On the other hand, prompt maintenance also plays an important role in extending the service life of the Flat Screen Printer . It’s advisable to take the following measures.

(1) When the phototube is damaged, the registration is wrong, the light control is out of order, and the photodiode and phototube should be adjusted.

(2) When the lift switch is out of order, and the machine stops, you should check whether travel switch is fine or not.

(3) When the scraper action fails, check the travel switch. When the times of squeegee is incorrect, the counting device is faulty.

(4) The whole machine electrical components need to be inspected whether the inspection work is normal once a week. In addition, check whether the screw is loose and the contact is good.

(5) If the temperature of the drying room can’t reach a standard level, the cloth is not dry, you can use the "up delay" or "down delay" to make appropriate operation, or start the exhaust to exclude water vapor.

(6) In the event of an accident, press the “Emergency Stop” button and the machine will stop running immediately. If the fault cannot be cleaned within 5 minutes, stop heating to remove steam.