1. Check the mechanical, electrical, instrumentation and safety protection devices before starting the Hot Air Stenter. According to the process requirements, set the temperature, and then turn on the circulating fan. In the heating stage, the host speed is 15m/min, and the set temperature can be reached. After meeting the requirements of the upper cloth, open the active brush wheel, press the cloth on the needle plate, try to make both sides flush, and at the same time put down the passive brush wheel and tighten the fabric. When starting the host, you should first ring the bell to inform the tail operator. When you put it to the rear of the car, you should wear the cloth at the fastest speed and tighten the fabric. The rear personnel should cooperate with each other before calling.
2. The safety cover of the machine should be in good condition to prevent the needle cloth from hanging around the sleeves, and also avoid the chain break and fly out and hurt people.
3. The rolling rope pull emergency stop switch and the feeding insurance are reliable and useful. When the cloth is operated, it must be stopped. Rolling up the upper roller should not be negligent.
4. The grey cloth must be seamed and not allowed to be knotted to avoid damage to the rubber roller.
5. Before shutting down Hot Air Stenter, the cooling should be reported to the hot-loaded heat transfer furnace room. Then stop the circulating fan operation, open the door to cool down, and run the main engine and the top exhaust fan separately, and the temperature can be reduced to 80 °C before stopping, which can avoid uneven heating of the chain clothing.
6. Regularly check the heat transfer oil pipeline in the oven. If there is oil leakage, it should be dealt with in time. After the shift, the fly flower should be cleaned, and the fly and oil in the exhaust pipe should be cleaned regularly to eliminate the fire hazard.
For further information about Hot Air Stenter, please move to hotairstenter.com