During the daily use of hot air stenter equipment, the user should not only pay attention to ensure the rationality and regularity of operation, but also take into account the safety aspects. The so-called safety not only requires keeping the hot air stenter equipment safe, but also to ensure the safety of the staff. So, what are the specific safety aspects to be aware of in the actual work?
First, about where the hot air stenter equipment is stored. Under normal circumstances, the equipment should be placed in a relatively spacious and well-ventilated environment free of corrosive gases. In addition, the location for the storage of the equipment should be level and dry, and the concrete thickness of the base floor should not be less than 150 mms. Also pay attention to ensure that the position of the two sides of the needle plate is flush and symmetrical, and do not allow any position deviation.
Secondly, during the installation of hot air stenter equipment, it is important to ensure that the tracks do not contain any impurities or other obstacles to the normal operation of the chain. During the installation of the drive rollers, guide rollers and drop rollers, the parallelism between the individual rollers needs to be calibrated.
Third, before turning on the hot air stenter equipment, be sure to check the prevailing environmental conditions. Remember, no other person should stand near the equipment; no service or maintenance personnel should be working. In addition, care should be taken to check and ensure that the temperature between the thermostat of the electrical control box should be within the prescribed range. If dust and other debris is found to accumulate in the electrical control box, it should be cleaned up in a timely manner.
In addition, before starting the temperature control program for hot air stenter equipment, the staff needs to take care to check the various drive components of the equipment in advance to ensure flexible operation. The full width is then adjusted to the desired width and adjusted in conjunction with the edge tracker, and the overfeed is adjusted to a predetermined value.