hotairstenter.com

A Detailed Explanation Of Hot Air Stenter Operating Specifications

Data:2021-03-29
Abst:...

  Before turning on the hot air stenter, the staff, you forgot to check it to ensure that it can be used stably. Then set the temperature according to the process requirements, and then turn on the circulating fan. During the heating stage, when the speed of the main engine reaches 15m/min and reaches the predetermined temperature, the cloth can be operated.

  When putting on the cloth, it should be noted that the two ends should be as flat as possible. When starting the mainframe of the stenter setting machine, a bell should be called to notify the operator at the rear of the car. When the cloth reaches the rear of the car, the cloth should be worn at a slow speed and the fabric should be tightened. The front staff should be prepared to cooperate. . Keep in mind that the position of the cloth in and out of the machine should ensure that its safety cover is intact and stable to prevent accidents.

  During operation, if any problems are found, the equipment should be shut down immediately without negligence. Also,

  The grey cloth must be sewn, and knots are not allowed to prevent damage to the rubber roller and cause safety accidents. If the operation is over, the stenter setting machine equipment should be shut down as required, and the cooling requirements should also be notified to the hot-load heat-conducting oil furnace before shutting down. Stop the circulating fan first and open the door to cool down. If its temperature drops to 80℃, it can stop.

  In the daily operation process, the staff needs to maintain good working habits, especially to check the heat transfer oil pipeline in the oven regularly. For example, if there is oil leakage, it should be dealt with in time. Also, we should also do a good job of eliminating the * care of the stenter setting machine, and keep it in a stable working state.

  It should be noted that no matter if the oil is added to the elimination operation, it should be carried out after the equipment stops running. If the stenter setting machine is in operation, do not wipe the chain, brush the needle plate, wipe the roller, etc. to prevent accidents.