hotairstenter.com

Problems Inclined Position of the Hot Air Stenter

Data:2018-11-07
Abst:...

Analysis and Discussion on the Problems of the Inclined Position of the Hot Air Stenter.

1. What is the working process of the hot air stenter?

The working process of the hot air stenter:

First, the unshaped cloth is fed into the hot air stenter setting machine through the stripper, and then the ends of the cloth are hooked on the needle board, and the two ends of the needle board are stepped into the belt with the mechanical operation. In the oven. After that, it is heated in an oven, and when it enters the tail end, it is cooled and destaticized. In this way, it is possible to drop the swing into the cloth, thereby obtaining the desired effect.

2. In the hot air stenter, what is the burner used? In addition, if the hot air stenter setting machine produces an oblique position, how to deal with it?

In the hot air stenter, the burners used generally look at the technical requirements and the specific configuration. Therefore, there are many brands for everyone to choose. As for the hot air stenter setting machine, the processing is as follows: if the setting machine has two motors, then it can be solved by adjusting the motor speed, and if it is a motor, then it is Add a weft feeder to the feed frame and the front of the car.

3. After the jersey has passed through the hot air stenter, if there is a vertical mark on the surface, what is the problem?

If this problem occurs on the hot air stenter setting machine, then the specific reason is that the shrinkage rate of the fabric structure is too large. Moreover, sometimes, this is inevitable. Through the hot air stenter, only fine-tuning can be done, and this problem cannot be completely solved. Therefore, everyone should pay attention to it and should not take it lightly.

Choose a professional hot air stenter manufacturer is important, here i recommend you https://www.hotairstenter.com/ , welcome your visit.